PFsense boot loop after power loss

I had just installed pfsense in my computer and using it as a router in my smb and am facing a issue of boot loop after every power loss. I am using a UPS but it can run upto 40 minutes.
Power cut in area sometimes go for more than 1 hour so is there any good way to resolve this issue that whenever the power comes pfsense will boot directly and does not go into boot loop??

thanks in advance :smiley:

What do you normally do to get it booting after the loop happens?

Is there any clue in the logfile what causing the reset?

1 Like

I usually have to shutdown the device physically by pressing the power button and then again power it on !!